The Dual Holeless system uses direct acting pistons and is best suited for lower travels. This system can range from small passenger lifts to large freight cars.
Above features a typical layout for a Front(left) or Front & Rear (right).
1 – Different shaft sizes from those listed in the above table can be accommodated by Amerivator Systems Corporation. Please contact our engineering department to determine the capacity options available to you at your given dimensions.
2 - Pocketing a door will reduce the required hoistway depth for a given capacity.
3 – All dimensions are for information only and cannot be used for construction without being confirmed by Amerivator Systems Corporation
Pit & Overhead Requirements
The minimum pit depth is 4’-6” deep. The minimum overhead is 12’-4” for a cab of 8’-0” high up to 12 feet of travel. A telescopic jack will be used for higher travels. Check with Amerivator Engineering.
The machine room should be adjacent to the shaft, usually at the lowest floor served for ease of installing the oil line. Please see our standard above. Please contact engineering for any other layouts.